ITEMS ORDERED IN STOCK ARE SENT EVERY DAY 12PM. Orders placed before 9AM go the same-day!
$0.00 / 0 items
0
0
KTM300EXC/XC and Husky TE300 2008-2016 Complete Rebuild Kit – TSP

$729.32 ex GST

KTM300EXC/XC and Husky TE300 2008-2016 Complete Rebuild Kit – TSP

$729.32 ex GST

piston kit
KTM300 CARBY Piston 04-19
Piston Size
KTM250/300 Seal Kit 0416 258SR

In stock

complete gasket set
KTM250/300 F Gasket 0816 134FL

In stock

connecting rod kit
KTM250/300 Rod 04on 03.6323

In stock

main bearings
Main Bearing KTM250/300 NJ207

In stock

main bearings
Main Bearing KTM250/300 6232C3

In stock

TSP Piston EZ-Clips (Circlips) pair for KTM/Husky 250 & 300 Models

In stock

In stock

Quantity

This TSP complete rebuild kit will suit KTM300EXC/XC and Husky TE300 models from 2008-2016. Images shows the 2017-on 300 kit, however the 08-16 300 kit is basically the same, except it does not come with the rubber spark plug cover.

It includes:

  • Piston kit in the size of your choice (A or B). Piston kit includes rings, pin, circlips and a high quality cast piston with anti-friction coating. These pistons are made in Italy and are THE BEST available.
  • Complete gasket kit. Made in Italy and packed especially for TSP. Includes a selection of base gaskets, powervalve cover gaskets, copper washers and O rings… all O rings are the correct size and made from the correct material, unlike the cheaper aftermarket kits.
  • Pro X con rod kit (includes little end bearing). Made in Japan.
  • Left and Right main bearings. Usually NTN or KOYO. Made in Japan.
  • Complete engine seal kit. Made in Italy and packed especially for TSP. Includes all oil seals, crank seals, water pump seals, etc.
  • As of November 2021, it now includes piston EZ clips free of charge (worth $29.95) for ease of piston installation

TSP rebuild kits are put together by TSP using parts sourced direct from OEM manufacturers in Japan and Europe. The parts we select are THE BEST available for each make/model and many are the exact same parts as the genuine items. All TSP rebuild kits are kept in stock at TSP.

Piston sizing: ideally you should measure your bore with a dial gauge to work out the correct piston sizing. If you cannot do this then a rough rule of thumb is use an A size under 100 hours of engine run time and use a B size over 100 hours of engine run time. Its ALWAYS better to have a bit too much clearance than not enough, so if in doubt use an A size.

Additional information

Weight2.5 kg
Piston Size

,